You find the CAD files linked above to make your own.

Or get them made for you over at the Bazar.

https://bazar.preciousplastic.com/moulds/injection-moulds/beads-mould-clone/

Removing the parts can be sometimes a bit hard. There are two ways to ease up the process a lot.


1.) Pressurized Air - drill a very small hole (<1mm) into the inside piece of the mould followed by a larger hole from the other side.
After you injected a piece use a blow gun of an air compressor to pop out the parts easily. If done right the plastic won't flow beyond the small hole.


2.) Add a bolt instead of pressurized air to the inside piece of the mould and cut a thread inside. Then after injecting you can screw in the bolt and the parts will fall out easily. This way you stay mobile for workshops out in the open ;)

Altough small you can get some nice assemblies of flowers or cactus in them :)

Inspired by the design of El Tornillo (https://tinyurl.com/ElTornilloTaller)